Cyclades AlterPath BladeManager Manuál s instrukcemi stáhnout pdf (Strana 77)

Chapter 5: Using the Web Manager 63

To configure the network interfaces (Wizard):

1. Click the Wizard button.

2. Select the Network interfaces option in the left menu bar.

3. Modify the name in the Host name field, if desired.

4. Enter or modify an existing DNS domainname in the Domain name field.

5. Enter or modify the IP address for a primary DNS server into the Primary DNS field.

6. Enter or modify the IP address for a secondary DNS server in the Secondary DNS field.

7. Enable or disable failover by selecting the desired option from the Failover pull

-down menu.

8. Click the Next button.

• If failover is disabled, clicking the Next button brings up the first of two screens for

configuring the primary and secondary Ethernet ports.

NOTE: Connecting the secondary Ethernet port to a separate network and assigning a separate IP address is

optional, so you can skip the screen for configuring the secondary Ethernet port, if desired.

• If failover is enabled, clicking the Next button brings up a screen for configuring the

failover device.

9. If desired, enable DHCP on any of the network interface configuration screens, by clicking the

DHCP checkbox.

10. If desired, configure the selected Ethernet port to use a static IP address by performing the

following steps:

a. Disable DHCP by making sure the DHCP checkbox is not checked.

b. Enter or modify the IP address in the IP address field.

c. Enter or modify the netmask in the Network mask field.

d. Enter or modify the IP address for a network gateway in the Gateway IP field.

e. Enter or modify the maximum transmission unit value for the Ethernet port in the

MTU field.

f. Enter or modify the broadcast IP address for the Ethernet port in the Broadcast IP field.

11. If failover is disabled and the current Ethernet port is the primary Ethernet port, click the Next

button and perform step 10 again on the secondary Ethernet port configuration screen for the

secondary Ethernet port, if desired.

12. Click Save and apply changes.

13. Click Next, if desired, to go to the next Wizard screen.

Configuring Subnets and Virtual (DNAT) Networks in the Wizard

After selecting the Subnets menu option, from the Wizard menu, the administrative user should

configure at least one private subnet and one or more optional virtual (DNAT) networks based on a

predefined addressing scheme. Deciding which addressing scheme to use is discussed in Private

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 239 240

Žádné komentáře

Cyclades AlterPath BladeManager Manuál s instrukcemi Strana 77