Cyclades AlterPath BladeManager Manuál s instrukcemi stáhnout pdf (Strana 29)

Chapter 2: Basic Installation Procedures 15

1. Use the SP manager’s dynamically assigned IP address in a browser to bring up the

Web Manager.

2. Finish configuring target devices, users, and other SP manager parameters using the

Web Manager.

3. Make sure that the root user changes the password by logging into the SP manager console.

See To change root’s password: on page 15.

To use the default IP address to access the Web Manager:

NOTE: The default IP address for the MergePoint 5224/5240 SP Manager is 192.168.160.10. This procedure

assumes that you are able to temporarily change the IP address of a workstation that is on the same subnet as

the SP manager.

1. On a computer with a physical network connection to the SP manager, change the network

portion of the IP address of that computer

to 192.168.160 and make sure that the host portion

of the IP address is not the same as that of the SP manager.

2. Bring up a browser on the computer whose address you changed, enter the SP manager’s

default IP address (http://192.168.160.10) to bring up the Web Manager, and log in.

3. To allow subsequent use of the Web Manager from any computer, click the Wizard button and

select the Network Settings option to change the SP manager’s IP address to a fixed public IP

address and to configure the other basic network parameters.

4. Restore the computer’s previous IP address.

Changing the root User’s Password

Whatever method is used to enable access to the Web Manager, the root user must always log into

the console and change the password from the default. The admin user cannot change the root

user’s password, and the root user cannot log into the Web Manager to change the root password.

The following options are available:

• Until an IP address is available for the MergePoint 5224/5240 SP manager, the only way that

the root user can change the root password is to log in locally through the console port. See To

configure basic network parameters using a terminal: on page 14.

• After an IP address is available for the SP manager, the remote root user can use ssh to connect

to the console and log in from a remote location and change the password.

To change root’s password:

1. Use SSH to connect to the console using the SP manager’s IP address or DNS name.

2. When prompted, login as root.

The default password is cyclades.

Sent username “root”

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 239 240

Žádné komentáře

Cyclades AlterPath BladeManager Manuál s instrukcemi Strana 29