Cyclades AlterPath BladeManager Manuál s instrukcemi Strana 192

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 240
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 191
178 MergePoint 5224/5240 Service Processor Manager Installer and Administrator Guide
You cannot change templates whose name ends with the .default suffix. sptemplate warns about
this restriction if you try to edit or rename these templates, and it requests confirmation before
allowing you to create a new template with a .default suffix through the New, Rename or
Copy functions.
To find out if an existing command template works with a new target device:
1. Assign the target device the appropriate device type and the associated default command
template for the device type.
2. Try to run power management commands on the target device.
3. If the target device is an RSA II type device, if you cannot run power commands on the target
device using the rsa.default template, assign the target device the rsa.limited.default template.
4. If you can run power commands on the target device, test the rest of the management
commands that are supported on the device type. If they work, you are done.
5. If you cannot run one or more of the supported commands on the target device, attempt to
connect to the SP console.
NOTE: Even if the power management commands do not work on a new target device, you can usually establish
a connection to the SP’s console.
6. If you cannot access the SP console, perform the following steps:
a. Use
ping, telnet or ssh to verify that you can get to the server.
b. If you cannot access the server, check the network configuration and fix the problem that
is preventing access.
7. If you can access the server but still cannot access the SP’s console, double-check the
username and password you are using against the username and password that are configured
for the target device.
8. Once you have established the connection to the SP’s console, type the help command, which
gives you the syntax you need to use for the commands supported by the SP.
9. Note the syntax of the commands supported by the SP’s console, and go to the next procedure.
To use the sptemplate utility to create a new template:
Perform this procedure after To find out if an existing command template works with a new target
device: on page 178, if the default templates do not work for a new target device.
NOTE: If you select Config - Target device type in the Web Manager and select the Configure target device
templates button, you are logged into the console and the sptemplate utility automatically launches, so you can
go directly to Step 2
1. Log into the console as an administrator and run the sptemplate utility.
2. Select New from the menu.
3. Enter a name, such as rsa.new. The editor brings up a template for a new command template
and assigns it the name you specified.
Zobrazit stránku 191
1 2 ... 187 188 189 190 191 192 193 194 195 196 197 ... 239 240

Komentáře k této Příručce

Žádné komentáře